Skip to content
Cabarrus County · Concord, NC

Standby Power That Carries Your Concord Home

A generator sized off your real load, an automatic transfer switch that flips the moment Duke Energy drops, and the gas hookup, permit, and Cabarrus County inspection coordinated by Bobby Shaver. When the power goes, your home stays running.

Why sizing decides everything

A generator that’s too small trips. One that’s too big is money on a pad.

Concord sees its share of outages, from summer storms rolling through Cabarrus County to the ice events that take down lines in winter. A standby generator is the difference between waiting out a two-day outage in a dark house and never noticing the utility went down. The catch is that a generator install is only as good as the sizing behind it, and that is where most installs go wrong.

Bobby sizes the generator off your actual load and the loads you want protected, not off a square-footage chart. The starting current of an air conditioner or a heat pump compressor is the load that catches people out. A generator that runs the fridge and lights fine will stall when the HVAC kicks on if it was undersized for that surge. With a managed whole-home approach, an automatic transfer switch plus load shedding lets a right-sized air-cooled unit carry the whole house, including HVAC, by shedding non-essential loads during peak draw and bringing them back when the surge passes.

The install covers the generator set on its pad, the automatic transfer switch wired into your service, the fuel connection to natural gas or propane, and the whole job permitted through Cabarrus County and inspected. Bobby coordinates the fuel side with Piedmont Natural Gas or your propane supplier and confirms the gas line can actually supply the generator under load, which is a detail that gets missed on installs that fail their first real outage.

Call (704) 575-9463 or reach out online for a walk-through. See finished work on the project gallery.

01

Load study and sizing

Bobby calculates your real demand and the loads you want backed up, then sizes the generator to carry them, including HVAC surge, without stalling.

02

Transfer switch and fuel

The automatic transfer switch is wired into your service and the fuel connection made to natural gas or propane, coordinated with the supplier.

03

Cabarrus County permit

The electrical and, where needed, gas permits are pulled through the county or the City of Concord and the inspections scheduled.

04

Commission and test

The unit is started, the transfer tested under load, the exercise schedule set, and the install handed off inspected and ready for the next outage.

Generator work we handle

Standby power for Concord homes and businesses

Whole-Home Standby

An automatic air-cooled unit with load management carries the whole Concord home, HVAC included, and switches over on its own the moment utility power drops.

Essential-Circuit Backup

A smaller managed install covers the fridge, well pump, heat, and a handful of circuits when full-home coverage is more than the household needs.

Automatic Transfer Switch

The ATS is the heart of the system. It starts the generator, transfers your home, and isolates from the grid so the unit can’t backfeed the line.

Natural Gas Hookup

Where Piedmont Natural Gas serves the address, a gas-fed generator never needs refueling. Bobby confirms the line can supply the unit under load.

Propane Systems

Outside gas service, a propane tank feeds the generator. Bobby coordinates the tank sizing and supplier so the runtime matches your outage exposure.

Commercial Standby

For Concord businesses that can’t afford downtime, Bobby scopes commercial standby with the right transfer gear for critical circuits and equipment.

Serving Cabarrus County

Concord outages don’t warn you. A standby system doesn’t need one.

Cabarrus County storms take lines down without notice, and a home office, a medical device, a well pump, or a freezer full of food turns a routine outage into a real problem fast. A properly sized standby generator with an automatic transfer switch means the lights flicker for a few seconds and the house comes back on its own, no cords, no manual switch, no scramble in the dark.

Bobby works Concord, Kannapolis, Harrisburg, Midland, and the surrounding Cabarrus County communities from the Norwood base. Generator installs run on equipment lead time plus a couple of days on site. Call (704) 575-9463 or contact us online to start the load study.

Cabarrus County’s outage pattern is what makes standby power worth the investment here. Summer storms roll through and drop lines for hours, and the winter ice events that come through every few years take longer to restore because the whole region is calling at once. A home on a well loses its water when the pump loses power. A freezer full of food is a real loss on a two-day outage. A home office cannot afford a workday in the dark. The generator that solves all of that is only as good as the sizing behind it, which is why Bobby leads with the load study rather than a brochure kW number.

Where the address sits changes the install more than most homeowners expect. Piedmont Natural Gas serves a lot of Concord, and where it does, a gas-fed generator never needs refueling through a multi-day outage. On the outskirts toward Midland and the more rural Cabarrus addresses, propane is the fuel, and the tank sizing has to match the generator’s draw against how long you assume the grid stays down. Either way, Bobby confirms the fuel line can actually supply the unit under full load, a detail that gets skipped on rushed installs and shows up as a generator that stalls the first time it has to carry the whole house. He tests the transfer under load before closeout so you watch it work before the first real Duke Energy outage does.

Common questions

Concord standby power, answered

What size generator does a Concord home need?
It depends on what you want to keep running. A managed whole-home approach with an automatic transfer switch and load shedding lets a 22kW to 26kW air-cooled unit carry most Concord homes including HVAC. A smaller unit covering essentials like the fridge, well pump, and a few circuits can land at 14kW to 18kW. Bobby sizes the generator off your actual load and the loads you want protected, not off square footage alone.
Does the generator run on natural gas or propane in Concord?
Both work. Where Piedmont Natural Gas serves the address, natural gas is convenient because you never refuel. Outside gas service, a propane tank feeds the unit. Bobby coordinates the fuel side with the gas company or the propane supplier and confirms the meter and line can supply the generator’s demand under load.
What is an automatic transfer switch and do I need one?
An automatic transfer switch senses when utility power drops, starts the generator, and switches your home over without you touching anything, then switches back and shuts the generator down when Duke Energy power returns. For a standby whole-home generator it is the core of the install. It also keeps the generator safely isolated from the grid so it can’t backfeed and endanger line crews.
Is a generator install in Concord a permitted job?
Yes. A standby generator install involves the electrical connection, the transfer switch, and usually a gas line, and it is permitted and inspected in North Carolina. Bobby pulls the electrical permit through Cabarrus County or the City of Concord and coordinates the gas permit and inspection where required.
How long does a whole-home generator install take in Concord?
Most standby installs are one to two days on site once the equipment and pad are ready, plus lead time on the generator itself and coordination with the gas supplier and Duke Energy. Bobby gives you a realistic timeline at the walk-through, including the inspection scheduling.
Will a generator protect my well pump during a Concord outage?
Yes, and for homes on a well it is often the main reason to install one. A well pump is a motored load with a starting surge, so it has to be part of the load calculation, not an afterthought. A properly sized standby unit with an automatic transfer switch keeps water running through the whole outage, whether that is a summer storm or a multi-day ice event in Cabarrus County. Bobby sizes the generator so the pump, the fridge, the HVAC, and the rest of what you want backed up all run without the unit stalling when the pump kicks on.
Does a Concord generator install include the concrete or composite pad?
Yes. The generator sits on a level pad set at the manufacturer’s clearance from windows, doors, and vents and to Cabarrus County setback rules. Depending on the site and the unit, that is either a poured concrete pad or a composite pad, and it is usually set before the electrical and fuel work so the generator lands ready. Bobby handles the placement as part of the scope and walks the location with you at the load study so you know exactly where the unit sits before anything is poured or dug.

Keep the power on in Concord when the grid drops

Load study, right-sized generator, automatic transfer switch, fuel coordination, permit, and inspection, handled start to finish.

(704) 575-9463